English | Español | Русский | Deutsch

Contáctenos | Búsqueda

Outside Division Plate and Face Liner Combination

This design allows quick, easy changing or reversing of the mold face liner without disassembling the mold box. This design permits hardening to a greater depth which makes the liner more abrasion resistant without sacrificing flexibility. The liner has two usable surfaces doubling its service life. The face liner is available in any of the standard mold heights and lengths. Additional sizes and styles are available. Parts are also available in metric sizes.

Use this division plate to prevent spreading of the mold side bars when producing solids or other difficult units. It is necessary to drill the side bars to accommodate these plates. Additional sizes and styles are available. Parts are also available in metric sizes.

 

Center Division Plate with Threaded Tangs, 9-1/4" High x 3/4" Thick
No. 057589	Center Division Plate with Threaded Tangs for 7-5/8" High x 15-5/8" Long Units
Inside Division Plate with Threaded Tangs, 9-1/4" High x 1/2" Thick
No. 079497	Inside Division Plate with Threaded Tangs for 7-5/8" High x 15-5/8" Long Units
No. 234025	Inside Division Plate with Threaded Tangs for 7-5/8" High x 17-5/8" Long Units
No. 087810	Hex Nut - 1"
No. 087908	Shakeproof Washer - 1"

Mold Face Liners with Ribs

Face liners with single or multiple ribs are designed for use on outside division plate No. 200545 for 15-5/8" long units. All face liners are 9-1/4" high. Additional sizes and styles are available. Parts are also available in metric sizes.